Hot Max Torches PL-25 - Manual (Page 8)

Note: A pressure regulator must be used with nitrogen gas from a cylinder.
 The pressure from the nitrogen gas cylinder to the PL-25 should never exceed 150 psi.
 Install a hose between the regulator and the PL-25 inlet.
Installation/Setup
Damaged Cylinders Can Explode.
Warning
 Keep cylinder upright and secured to a stable support.
 Keep cylinder clear of areas and items that could damage the cylinder.
 Be careful not to allow the cutting torch to touch the cylinder.
 Always keep the cylinder clear of electrical parts.
 Maximum pressure 150 psi.
KDAR Company
6