Dake Model G-75 - Manual (Page 3)

5/20/2010
Model G-75 3
MACHINE PLACEMENT/ SET UP / INSTALLATION
1. Machine Placement:
1.1 Anchoring the machine:
NOTE: Machine must be located away from flammable areas, congested areas, traffic
areas, and areas where others will be working!
Grinder exhaust should always face an area that is unoccupied, never toward other workers, aisles or
areas that contain waste containers, rags, etc.
Grinder should always be positioned so operator can be accessible to all sides and that there are no
trip hazards or liquids present.
Grinder must be anchored on a level hard surface! Machine must be removed from the pallet.
Anchoring of the machine must be done to prevent movement of the unit during operation. The base is
supplied with four mounting holes on the four corners. (Figure 1) Anchoring must be done in a suitable
fashion.
Correct Belt Rotation
1.2 Power Hook Up:
NOTE: Before connecting power make sure power is OFF and make sure there are no
damaged parts on the machine, and that all components (wheels and belts) move freely and
are not rubbing on material rests etc.!
A qualified electrician must do connection of power to this machine. Machine is supplied
with a power cord that cam have a plug installed or can be hardwired into a suitable power
source. 20-amp service is recommended for this machine.
Rotation on this machine must be in the correct direction. The belt is to travel forward from the
motor end of the unit. (Figure 2) If rotation is incorrect simply reverse to leads from the
incoming power.
This machine is equipped with CE certified components with low voltage drop out, and flip up
start feature to prevent accidental starting.
Figure 1 Figure 2