Dake Model Trademaster - Section I - Manual (Page 4)

4/29/03
Model Trademaster Section I - 4
IMPORTANT SAFETY INSTRUCTIONS
Warning: Failure to follow the following safety precautions may result in serious injury.
KEEP WORK AREAS CLEAN. Cluttered benches and workstations invite accidents
and create potential fire hazards. Floors must be kept clean and free from oil, wax,
sawdust or other debris. Promote cleanliness and reduce accidents and fire hazards.
CONSIDER WORK AREA ENVIRONMENT. Keep alert to potential hazards in the
work environment. Do not use electrical machinery in damp or wet locations. Keep
machinery clear of the presence of highly combustible materials, dust, flammable
liquids, fumes, vapors and gases.
WEAR PROPER APPAREL. Do not wear loose fitting clothing, gloves, neckties or
jewelry. They can be caught in moving parts. Non-skid footwear is recommended.
Wear eye, face, ear, respiratory and body protection equipment appropriate for
operating environment. Wear protective hair covering to contain long hair. Roll long
sleeves up above elbows when operating the saw.
USE SAFETY GLASSES. Eye protection is required at all times when using this
machine.
DON’T ABUSE POWER CORD. Keep cord from heat, oil and sharp edges.
DON’T FORCE TOOLS. Machinery performance will remain at higher and safer levels
if it is not pushed beyond the limits of its capability.
SECURE ALL WORK. Use clamps, vices, fixtures or jigs to hold work when it’s
practical. It’s safer than using your hands and it frees both of your hands to operate the
machine. Use a push block to hold or guide work when working close to the cutting
tool.
DON’T OVERREACH. Keep all hands well away from moving parts; saw blades and
other cutting tools. Keep proper footing and balance at all times.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safe
performance. Follow instructions for maintenance and changing accessories. Keep
handles dry, clean and free from oil and grease. Damaged parts should be inspected
before further use of the tool. Check alignment of all moving parts. Look for binding of
moving parts, breakage, mounting and any other condition that may affect machine
operation. Any part or guard that is damaged should be properly repaired or replaced
prior to further use.
DISCONNECT MACHINE. Make sure machine is unplugged from it’s power source
before servicing and when changing accessories, such as blades.
NEVER LEAVE MACHINE RUNNING UNATTENDED. Before leaving machine, turn
the power off. Do not leave the machine until it comes to a complete stop.