Dake Model SAR 440 - Manual (Page 7)

7
SAR 440 SA GDS
4.3 - Minimum requirements for the premises
housing the machine
- Mains voltage and frequency complying with the machine motor
characteristics.
- Environment temperature from -10 °C to +50 °C.
- Relative humidity not over 90%.
4.4 - Anchorage of standard machine
- Position the machine on a firm cement floor, maintaining, at the
rear, a minimum distance of 1000 mm from the wall; anchor it to
the ground as shown in the diagram, using screws and expansion
plugs or tie rods sunk in cement, ensuring that it is sitting level.
4.5 - Instructions for electrical connection
- The machine is not provided with an electric plug, so the customer
must fit a suitable one for his own working conditions:
1 - WIRING DIAGRAM FOR 4-WIRE SYSTEM FOR THREE-
PHASE MACHINE - SOCKET FOR A 16A PLUG
R = L1
S = L2
T = L3
PE = GND
4.6 - Instructions for assembly of the loose parts and
accessories
Fit the components supplied as indicated in the photo:
- Mount the stock stop.
- Mount the coolant liquid holder.
4.7 - Disactivating the machine
- If the sawing machine is to be out of use for a long period, it is
advisable to proceed as follows:
1) detach the plug from the electric supply panel
2) loosen blade
3) empty the coolant tank
4) carefully clean and grease the machine
5) if necessary, cover the machine.
4.8 - Dismantling
(because of deterioration and/or obsolescence)
General rules
If the machine is to be permanently demolished and/or scrapped,
divide the material to be disposed of according to type and composi-
tion, as follows:
1) Cast iron or ferrous materials, composed of metal alone, are sec-
ondary raw materials, so they may be taken to an iron foundry
for re-smelting after having removed the contents (classified in
point 3);
2) electrical components, including the cable and electronic ma-terial
(magnetic cards, etc.), fall within the category of material classi-
fied as being assimilable to urban waste according to the laws of
the European community, so they may be set aside for collection
by the public waste disposal service;
3) old mineral and synthetic and/or mixed oils, emulsified oils and
greases are special refuse, so they must be collected, transported
and subsequently disposed of by the old oil disposal service.
NOTE: since standards and legislation concerning refuse in gen-
INGOMBRO OPERATIVO = mm 2400
INGOMBR
O OPERA
TIV
O = mm 3000
QUADRO ELETTRICO