Dake Model SAR 440 - Manual (Page 12)

12
SAR 440 SA GDS
7.5 - Blade-cleaning brush
Ideal for the cleaning of the blade during its cutting cycle.
Periodically check the integrity of the brush and if necessary
proceed to an ulterior regulation to guarantee cleansing of
the blade.
7.3 - Vice
- - The rapid advancement of the vice to the object to be cut is
obtained by manually moving the vice and lifting the latch ( F ).
Before blocking the object to be cut with the hand wheel check
that the latch is gripped to the rack.
- The vice unit can be positioned to the left or right of the blade.
Ensure that this positioning has been executed correctly in order
to avoid irreparable damage to the saw.
- It is recommended to keep the vice guide and ribbon clean and
oiled at all times.
7.4 - Regulating the cutting angle
- Lift the sawframe.
- Operate the Lever ( G ) to release the rotation of the device.
- Rotate the sawframe to the desired angle referring to the
graduated sector.
- Tighten the lever ( G ) to block the device from rotating.
It is an accessory that permits the execution of lifting and/or near-
ing of the arch.
- Operate the selector button ( H ) to move the arch up and
down to the desired position.
7.7 - Regulating the cutting speed
Regulation of the cutting speed can only be done with the motor-
belt in motion.
To change the running speed, adjust with hand wheel and refer to
the plaque.
7.6 - Regulating the height of the cut
V
F
G
INDICE
COMPONENTE
PART.
LUBRIFICANTE
OIL TYPE
QUANTITA'
KG
RIDUTTORE
REDUCTOR
SHELL
TIVELA S320
1,6
VARIATORE
VARIATOR
SHELL
DO NAX TA
1,2
TABELLA LUBRIFICANTI
1
H
6