Dake Model Johnson J Saws - Manual (Page 4)

6/02
4
BASIC MACHINE DATA
SPECIFICATIONS
Capacity………...10” (25cm) rounds, 18” (46cm) flats Floor Space ……………… 29” (74cm) x 70” (178com)
Blade Size (Part Numbers: 75958 (3/4”) OR 75957 (1”) Height, Closed* …………………………….. 39” (99cm)
J-10 ……………………… ¾” (2cm) x 137” (348cm) Height, Open* ……………………………... 64” (163cm)
JH-10……………………... 1” (3cm) x 137” (348cm) Floor to Bed* …………………………….. 23 ¾“ (60cm)
Blade Speeds Net Weight
………………………………50, 90, 160 and 270 fpm J-10 Dry …………………………. 812 lbs (368 kgs)
………………………………..15, 29, 49 and 82 mpm J-10 Wet ..……………………….. 845 lbs (383 kgs)
Bed Work Area. ……..……… 11” (28cm) x 18” (46cm) JH-10 Dry ……………………..… 817 lbs (371 kgs)
Vise Size ………………………. 5” (13cm) x 11” (28cm) JH-10 Wet ……………………….. 850 lbs (386 kgs)
Drive Motor Gross Weight
J-10 ………………………………….…. 1 hp (.75kw) J-10 Dry …………………….…… 896 lbs (406 kgs)
JH-10 …………………………………... 1 hp (.75kw) J-10 Wet ……………………..….. 929 lbs (409 kgs)
Electrical System, specify …....110/230V, 1 PH, 60 Hz JH-10 Dry …………………..…… 901 lbs (409 kgs)
208/230/460V, 3 PH, 60 Hz JH-10 Wet ..……………………….934 lbs (424 kgs)
Coolant Capacity …………………………...… 3 gallons Water-soluble only – do not use oil.
INSTALLATION
UNCRATING : Remove crating carefully. For ease in handling do not remove from skid until
machine has been moved to its approximate location.
CAUTION: BE SURE ELECTRICAL CHARACTERISTICS OF MOTOR AND SWITCH
CORRESPOND WITH ELECTRICAL POWER SUPPLY.
!!!ATTENTION!!! DO NOT ATTEMPT TO RUN THIS SAW UNTIL THE BLADE ALIGNMENT HAS
BEEN CHECK AS PER THE OWNER’S MANUAL AND THE BLADE HAS BEEN PROPERLY RE-
TENSIONED.
LEVELING: Position machine reasonably level, shim under legs if necessary. Wet machines
should be more carefully leveled to be certain that the coolant intake remains submerged.
CONNECT INCOMING POWER TO THE STARTER PER APPLICABLE DIAGRAM, AND IN
ACCORDANCE WITH ALL LOCAL CODES.