Dake Model TRAD 300 - Manual (Page 7)

7
SUPER SUPER SUPER SUPER SUPER TRAD 300 MM TRAD 300 MM TRAD 300 MM TRAD 300 MM TRAD 300 MM
4.2 - Transport and handling of the machine
If the machine has to be shifted in its own packing, use a fork-
lift truck or sling it with straps as illustrated.
4.4 - Anchoring the machine
4.3 - Minimum requirements for the premises
housing the machine
- Mains voltage and frequency complying with the machine
motor characteristics.
- Environment temperature from -10 °C to +50 °C.
- Relative humidity not over 90%.
884
FRONTE
MACCHINA
PRO
FIL
O B
A
S
A
M
ENT
O
355 355
355 355
80 80
80.0 80.0
- Position the machine on a firm cement floor, maintaining, at
the rear, a minimum distance of 1000 mm from the wall; an-
chor it to the ground as shown in the diagram, using screws
and expansion plugs or tie rods sunk in cement, ensuring that
it is sitting level.
4.5 - Instructions for electrical connection
- The machine is not provided with an electric plug, so the cus-
tomer must fit a suitable one for his own working conditions:
1 - WIRING DIAGRAM FOR 4-WIRE SYSTEM FOR THREE-
PHASE MACHINE - SOCKET FOR A 16A PLUG
4.6 - Instructions for assembly of the loose parts
and accessories
R = L1
S = L2
T = L3
PE = GND
Fit the components supplied:
- Mount bar-stop rod
- Mount and align the roll supporting arm as per the counter-
vice table.
- Mount the metal protection against coolant splashing on the
left side of the machine base.
4.7 - Disactivating the machine
- If the sawing machine is to be out of use for a long period, it is
advisable to proceed as follows:
1) detach the plug from the electric supply panel
2) loosen blade
3) release the arch return spring
4) empty the coolant tank
5) carefully clean and grease the machine
6) if necessary, cover the machine.