Dake Model H-100 - Manual (Page 2)

10/09/07
Dake Power Hammer
2
Set up and Operation of the Dake Power Hammer
Once you remove the power hammer from the packaging you will need to install the shaping dies to be
used and the wheels.
WARNING !!!
Unplug the power hammer from the electrical source before changing the dies.
A. Remove the 6 bolts from the adjustable bottom sleeve.
B. Remove the adjustable bottom sleeve from the side plates.
C. Insert die holder with the desired die attached into the slider. Make sure the die holder is
bottomed into the slider.
D. Tighten the two hex socket set screws to secure the upper die holder.
A A
B
D
D
C