Dake Dura Press Force - 50 - Manual (Page 6)

3/29/2010 6
This machine is not designed for stripping operations. Personal injury or machine
damage can result.
Press set-up
Installation Instructions
Your new Dake Press has been packaged in a manner to prevent damage to any critical components; some
assembly will be required. All parts in the accessory box are critical to the function of your press. Some presses
may be pre assembled.
NOTE: FOR EASE OF ASSEMBLY LEAVE THE PRESS FRAME MOUNTED ON THE SHIPPING SKID
1. Remove plastic from the machine.
2. Open the box and you will see a pumping unit, with the press still laying on its side. Locate the four holes
on the side of the press facing up.
3. Place the pumping unit on the side of the press with the mounting bracket facing down, making sure the
holes all line up.
4. There are four bolts, washers and nuts in a bag, in the box. Put the bolts in the holes using the washers
and nuts. Make sure all nuts and bolts are tight.
5. With the press lying on its side fill the reservoir with DTE 24 Mobile oil or equivalent.
6. Look at picture on the next page to install all the fittings.
WARNING!!!!
Be sure all bolts and fittings are tight before operating this pumping unit, personal injury could result.