Steffy Wood Products Toddler Storage with Mirror Back - Manual (Page 2)

CHECK ALL BOLTS AND SCREWS
PERIODICALLY TO MAKE SURE
THEY ARE TIGHT!
5
(refer to sketch at left)
Attach the remaining side panel to the top
and bottom panel using the connector bolts
and hex wrench.
Mount the mirror to the back panel. Remove
the protective strips from the tape on the
back side of the mirror and attach the mirror
on the back panel. Press firmly around
mirror after it is in place.
4
(refer to sketch above)
Attach the bumper to the pre-drilled
hole in the bottom of the cabinet using
the 1" long screw.
3
(refer to sketch at right)
Slide the back panel into the slots in the top,
bottom and side panel. Be sure the panel is
completely in the slot in the assembled side
panel.
2
(refer to sketch at right)
Attach one side panel to the top and bottom panels using
four connecting bolts and the hex wrench. Be sure the
slots for the back panels are aligned in each panel.
Be sure the bottom panel is attached in the slot that is
CLOSER to the edge of the side panel.
6
Attach the top strips to the side and top panels
by inserting the plastic connectors in the top
strips to the connecting screws on the top and
side panel. Using the supplied screwdriver,
turn the screw located in the plastic connector
clockwise until tight.
Attach the divider to the top and bottom panel
using the connecting bolts and hex wrench.
Be sure the rounded edge is facing front as
you attach the divider.
LEFT SIDE
TOP PANEL
BOTTOM PANEL
BACK PANEL
SLOTS FOR BACK PANEL
1" LONG SCREW
MIRROR
RIGHT SIDE
DIVIDER
TOP STRIP
CONNECTOR
CONNECTING SCREW
CONNECTING SCREW
SLOT CLOSER TO EDGE