ADTRAN NT1 ACE4 - Manual (Page 22)

NT1 ACE 4 User Manual
6 NT1 ACE 4 User Manual 61200242L1-1
Powering with the NT1 ACE
4
Power Supply
The ADTRAN NT1 ACE
4
Power Supply, part number
336012VUR01, provides power to the NT1 ACE
4
. To connect
the NT1 ACE
4
to the external power supply, perform the fol-
lowing steps (see Figure 1-5).
1. Connect the power supply to the NT1 ACE
4
at the
POWER jack located on the NT1 ACE 4 rear panel.
2. Plug the power supply into the nearest wall outlet sup-
plying 120 VAC, 60 Hz.
3. On the NT1 ACE
4
, verify that the ERROR indicators
are illuminated. After approximately 15 seconds, the
READY
indicators should flash at a 1 Hz rate. Should
any of the indicators fail to operate as stated, see the
section Troubleshooting on page 8.
Figure 1-5. Power Supply Connection
100 - 120
VAC
NETWORK
POWER LOCAL
NT1 ACE 4
3 1 READY
ERROR
2 4