beautypg.com

Alto-Shaam 1000-TH-II User Manual

Page 4

background image

TH-II

INSTALLATION

/

OPERATION

/

SERVICE MANUAL

PG

. 3

S I T E I N S T A L L A T I O N

The Alto-Shaam cook

and hold oven must be

installed in a location

that will permit the

oven to function for its

intended purpose and

to allow adequate

clearance for

ventilation, proper

cleaning, and

maintenance access.

1. The oven must be installed on a stable and

level surface.

2. DO NOT install this oven in any area where it may be

affected by any adverse conditions such as steam,

grease, dripping water, high temperatures, etc.

3. DO NOT store or use any flammable liquids or

allow flammable vapors in the vicinity of this oven

or any other appliance.

4. This appliance must be kept free and clear of any

combustible materials.

5. This appliance must be kept free and clear of

any obstructions blocking access for maintenance

or service.

®

I N S T A L L A T I O N

Emissions testing conducted by Underwriters

Laboratories, Inc.

®

was found to be in compliance

with the applicable requirements of NFPA96: 2004

Edition, Par. 4.1.1.2. U.L emissions sampling of

grease laden vapor resulted in a total of 0.55

milligrams per cubic meter with no visible smoke

and is considered representative of all oven models

in the line. Based on these results, hood installation

and/or outside venting should not be a requirement

in most areas. Verify local codes for locations where

more restrictive codes are applicable.

MINIMUM CLEARANCE REQUIREMENTS

COMBUSTIBLE

SURFACES

NON

-

COMBUSTIBLE

SURFACES

BACK

3" (76mm)

3" (76mm)

LEFT SIDE

1" (25mm)

1" (25mm)

RIGHT SIDE

1" (25mm)

1" (25mm)

TOP

2" (51mm)

2" (51mm)

D A N G E R

IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH
OR CAUSE PROPERTY DAMAGE.

READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.

C A U T I O N

TO PREVENT PERSONAL INJURY,

USE CAUTION WHEN MOVING OR

LEVELING THIS APPLIANCE.

C A U T I O N

METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.

D A N G E R

DO NOT store or use gasoline or other

flammable vapors or liquids in the

vicinity of this or any other appliance.

This manual is related to the following products: