Videoswitch Vi200 - Manual (Page 44)

Digital Recorder
38
14 Technical Data
14.1 Power-On Reset
If you wish to perform a power-on-reset to restore all settings to their factory defaults, press
the
DEF key while you apply power, and keep pressing it until the Vi200 has powered up
and displays
FACTORY RESET. Note that this process will reset all user settings, including
camera titles. The
DEF key will need to be pressed for about 10 seconds.
The factory configuration can also be recalled via the menu (see section 9.6.4).
14.2 Accessories Included
Vi200
Mains Cable
Vi-X1 Alarm Break-out module
Hard Drive Key
Manual
CAT5 Ethernet Cable
Blank CDs (2)
14.3 Changing the Hard Drive
Hard drives are sensitive mechanical devices that may be damaged by shock or vibration.
Always protect them from shock and vibration when transporting.
Remove power from the Vi200 before removing the hard drive. Wait for 30 seconds for the
drive to stop spinning before moving the Vi200 or removing the hard drive. Moving a drive
that is still spinning can damage it.
The hard drive drawers require a special key to unlock them. This is supplied with the Vi200.
Insert the key, and turn it clockwise to unlock the drive.
To put a hard drive back into the Vi200, make sure that the lock in the drive drawer is in the
unlocked position. Carefully slide the drawer in as far as it can go with the handle in the up
position. Carefully push the handle down such that the drawer is pulled into the drive bay.
When it is properly located, lock the drawer by turning the key counter-clockwise.
After changing a drive, re-apply power to the Vi200.