VariZoom VZHDARM - Manual

VZ-HDARM – Heavy Duty Articulated Arm
The HD Arm is extremely simple to operate. The clamp can be attached to tubes as shipped, or if you
remove the wedge-shaped “saddle” and insert it into the V-groove, the clamp will attach to flat
surfaces (like table edges, doors, thin walls, etc.).
The arm itself attaches to the clamp at the hex socket. You’ll have to loosen the locking screw and
depress the safety catch pin to insert the arm joint into the hex socket, then tighten the locking screw.
Adjusting the arm is very intuitive. Simply loosen the large handle in the center and you’ll see the end
joints can rotate. Loosen the large handle enough and you can disengage the serrated clutch in the
middle and change the angle of the two main arm sections. The position of the large handle can also
be rotated without loosening the joint by lifting the handle up and turning it (lifting disengages the
screw mechanism).
The included brass stud is threaded ¼”-20 one end and
3/8”-16 on the other end – likewise with the arm end joints.
Also included are ¼”-20 and 3/8”-16 studs w/ washers for
increased mounting flexibility and for mounting to the
VariZoom QuickJib or SnapCrane (late models only).
The HD Arm is very intuitive and robust, so we encourage
you to play around with it to get the best idea of how to use
it for your needs. It’s hard to use it wrong – just don’t try to
take it apart, because that’s one thing we don’t cover under
warranty! Thanks for your purchase!
www.varizoom.com / 512-219-7722
Warranty: 2 years parts and labor
Remove saddle and insert into
V-groove for flat clamping