VariZoom VZUSPG350 - Manual (Page 2)

2
3. With the focus-control handle and focus block firmly attached, you
can connect the drive cable. Start by taking one end of the cable in
your hand – observe the flat-head tip protruding – this flat-head will
fit into a slot located in the socket of the focus-control handle. Align
the flat-head tip with the slot in the threaded socket and insert,
holding it so the focus-control handle can be turned enough to
ensure a proper fit. If the flat-head tip is firmly in place, the tip on
the other end of the drive cable will rotate smoothly.
4. At this point, slide the threaded metal cap onto the threaded socket
and tighten thoroughly.
5. Attaching the drive cable to the focus block is essentially the same
as described in steps 3 & 4 (note: focus block may differ from the
one pictured). Align the flat-head tip of the cable with the slot in the
threaded socket located on the focus block. Insert the flat-head tip
and hold the cable in place, turning the focus control handle until the
whole unit moves smoothly – at this point the brass gear on the
focus block should easily turn the focus ring on the lens.
6. Once the whole unit rotates smoothly, you can slide the threaded
metal cap onto the threaded socket and tighten it thoroughly.
7. Start focusing.
www.varizoom.com / 512-219-7722