VariZoom VZDVRODS User Manual
Page 2
Inverted configuration
for EX1 w/ Quick
Release, Zero Gravity,
VZ-FC-U
Inverted configuration with HD100U
Basically, all you really have to do is figure out where the rods need to be placed
in relation to your camera lens and take that into consideration when selecting a
camera-mounting hole on the baseplate (place the locator pin in front of the
selected mounting hole to help prevent unwanted camera rotation). Once the
baseplate is mounted, adjust the vertical, horizontal, and fore-aft positions of the
rods until they reach the desired location. The same 1/8” hex key will be used for
mounting the camera and adjusting the vertical and horizontal positions of the
rods. The fore-aft position is easily changed with the attached thumbscrews.
The vertical and horizontal adjustment plates can also be inverted so that they
aim upward, allowing the entire assembly to slide further back on the tripod
and/or for greater upward adjustment range. This configuration could work well
for larger cameras (ENG type), or for cameras like the
Sony PMW-EX1 and –
EX3
when used in conjunction with a VZ-QRP quick release assembly on top of
the baseplate (both pictured below). Although not absolutely necessary for the
EX1 and EX3, this configuration
is recommended
because it allows a greater
range of aft adjustment on a tripod head, enabling you to better balance the
camera’s weight in instances where a heavy mattebox / filter / lens adapter setup
creates a front-heavy weight distribution. It also allows quick extraction of the
camera from the overall configuration with minimal hassle.
The two ¼”-20 holes on the back end of the base plate are for attaching rods to
the rear so that additional accessories can be mounted and aid in
counterbalancing the front-mounted accessories. These holes can also serve as
retaining spots for extra screws. VariZoom intends to introduce the back end
rods and brackets in the near future – please feel free to offer feedback!
Warranty period: 1 year – Warranty coverage: defects in materials or workmanship, does not
cover lost or damaged components – Returns/Repairs: RMA # is required – 512-219-7722