CDN TM9 - 2-Ev ENt Timer & Clock EN - Manual (Page 2)

4. Press the MEMORY button to enter the set time
into memory. MEMORY appears on the display.
1. Press the MEMORY button to recall the set
time.
2. Press the MEMORY button, then press the
CLEAR button, to clear the set time from
memory.
5. Select LOCK using sliding mode switch on back
of case to prevent unintended timer entry. The
digits stop flashing.
6. Press the START/STOP button to start counting
down.
7. Press the START/STOP button to interrupt the
count. Press START/STOP again to resume the
count.
8. The alarm sounds and TIME’S UP flashes on
the display when the count reaches 0:00
00
. The
timer counts up the overtime since reaching
0:00
00
. The maximum overtime is 10 hours.
9. The alarm and flashing stop automatically after
60 seconds while the count up continues. Press
START/STOP to stop the alarm and the count
up.
10. Press CLEAR when timer is stopped to reset to
0:00
00
. All flashing stops.
11. Press the MEMORY button to recall the set time
in memory.
12. To view and use both timers simultaneously,
select TIMER 1 & 2 using sliding mode switch
on left side of case.
C. Count Up
1. Select CLOCK using sliding mode switch on left
side of case.
2. COUNT UP appears on the lower portion of the
display.
3. Press START/STOP to begin the count.
4. Press START/STOP button to interrupt the
count. Press START/STOP button again to
resume the count.
5. To clear the display, press START/STOP to stop
the count then press CLEAR to reset the display
to 0:00
00
.
Care of Your Product
• Avoid exposing your timer to extreme temperatures,
water or severe shock.
• Avoid contact with any corrosive materials such as
perfume, alcohol or cleaning agent.
• Wipe clean with a damp cloth.
© 06-2013 Component Design Northwest, Inc. Made in China CD9999242en - 6/13 PROFORMA 614 760-5800
The information in this document has been reviewed and is
believed to be accurate. However, neither the manufacturer nor
its affiliates assume any responsibility for inaccuracies, errors
or omissions that may be contained herein. In no event will
the manufacturer or its affiliates be liable for direct, indirect,
special, incidental or consequential damages arisen by using
this product or resulting from any defect/omission in this
document, even if advised of the possibility of such damages.
The manufacturer and its affiliates reserve the right to
make improvements or changes to this document and the
products and services described at any time, without notice
or obligation.
5-Year Limited Warranty: Any instrument that
proves to be defective in material or workmanship
within five years of original purchase will be
repaired or replaced without charge upon receipt of
the unit prepaid at: CDN, PO Box 10947, Portland,
OR 97296-0947. This warranty does not cover
damage in shipment or failure caused by tampering,
obvious carelessness or abuse.
CE Note: This device could be sensitive to electrostatic
discharge. If electrostatic discharge or malfunctioning occurs,
please re-install the battery to reset this unit.