Care of your product – CDN TM8 - Multi-Task Timer & Clock EN User Manual

Page 2

C. Count Up – Stopwatch

1. Slide switch on the right side to COUNT UP to

select the count up mode.

COUNT UP appears

on the display.

2. Press the START/STOP button to start

counting up.

Note:

COUNT UP flashes on the display during count up

when in other modes.

3. Press the START/STOP button to interrupt

the count. Press START/STOP again to resume

the count.

4. Press CLEAR when timer is stopped to reset

0:0000.

Note:

The timer retains any time showing on the display

when the sliding mode switch is moved to another

position.

Care of Your Product

•

Avoid exposing your timer to extreme

temperatures, water or severe shock.

•

Avoid contact with any corrosive materials such as

perfume, alcohol or cleaning agents.

•

Wipe clean with a damp cloth.

Made in China

CD9999106en - 11/06

EHC 614 885-2497

��
��

The information in this document has been reviewed and is

believed to be accurate. However, neither the manufacturer nor

its affiliates assume any responsibility for inaccuracies, errors

or omissions that may be contained herein. In no event will

the manufacturer or its affiliates be liable for direct, indirect,

special, incidental or consequential damages arisen by using

this product or resulting from any defect/omission in this

document, even if advised of the possibility of such damages.

The manufacturer and its affiliates reserve the right to

make improvements or changes to this document and the

products and services described at any time, without notice

or obligation.

5-Year Limited Warranty: Any instrument that

proves to be defective in material or workmanship

within five years of original purchase will be

repaired or replaced without charge upon receipt of

the unit prepaid at: CDN, PO Box 10947, Portland,

OR 97296-0947. This warranty does not cover

damage in shipment or failure caused by tampering,

obvious carelessness or abuse.