Akiles ProLam 100 - Manual (Page 2)

▶
TIPS:
· ALWAYS TURN “OFF” THE APL-100 IF YOU WILL STOP LAMINATING FOR A LONG PERIOD OF TIME.
· ALWAYS MAINTAIN THE APL-100 ON STAND BY (POWER “ON” POSITION) IF YOU WILL CONTINUE
LAMINATING WITHIN A FEW MINUTES. THIS FEATURE WILL ALLOW YOU TO INSTANTLY RE-START
LAMINATING, WITHOUT DEPRECIATING THE MOTOR OR ROLLERS.
▶
TEMPERATURE ADJUSTMENTS:
· IF THE POUCH IS NOT SEALING WELL (IT APPEARS MILKY), THE TEMPERATURE MAY BE TOO COLD
FOR THE POUCH THICKNESS THAT YOU WISH TO LAMINATE.
CORRECTlVE ACTlON:
A. MAKE SURE THAT THE READY LIGHT IS ON.
B. IF THE READY LIGHT IS NOT ON SIMPLY WAIT UNTIL THE READY LIGHT TURNS ON AND
PROCEED TO LAMINATE-
C. IF THE READY LIGHT IS ON:
1 . TURN THE UNIT TO ITS SIDE (EXPOSING THE BOTTOM)
2. USE A FLAT SCREWDRIVER TO ADJUST (INCREASE) THE TEMPERATURE BY TURNING
CLOCK-WISE GRADUALLY THE SWITCH TOWARD THE “H”. WAIT APPROXIMATELY 1-2
MINUTES UNTIL THE READY LIGHT TURNS ON AND THEN PROCEED TO LAMINATE.
D. REPEAT STEP “C” AS NEEDED. NOTE: THERE ARE MANY DIFFERENT POUCHES IN THE MARKET,
THAT MAY REQUIRE MORE OR LESS HEAT TO PROPERLY SEAL.
· IF THE POUCH IS WAVY, THE TEMPERATURE IS TOO HIGH FOR THE POUCH THICKNESS THAT YOU
WISH TO LAMINATE
CORRECTlVE ACTlON:
E. PROCEED WITH STEPS A, B, C, AND D ABOVE. NOTE: TEMPERATURE CONTROL MUST BE
TURNED COUNTER-CLOCK-WISE TOWARD THE “L” TO LOWER TEMPERATURE.
CAUTION !
· DO NOT LEAVE THE APL-100 ON FOR LONG PERIODS OF TIME, WHEN IN USE.
· TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPERATE THE APL-100 NEAR WATER.
· DO NOT USE THE APL-100 IF POWER CORD IS DAMAGED.
· DO NOT ALLOW THE ELECTRIC CORD TO BE IN CONTACT WITH HOT SURFACES.
· IN CASE OF MALFUNCTION, RETURN THE UNIT TO YOUR DISTRIBUTOR FOR SERVICE. THIS
LAMINATOR DOES NOT CONTAIN ANY PART THAT CAN BE SERVICED BY THE CONSUMER.
▶
WARRANTY POLICY :
YOUR APL-100 HAS A WARRANTY OF ONE YEAR, FROM ITS PURCHASE DATE. IN THE EVENT OF A
MANUFACTURER’S DEFECT, YOUR DISTRIBUTOR (AT OPTION) WILL REPAIR OR REPLACE IT.
lMPORTANT : THIS WARRANTY DOES NOT COVER DAMAGES DUTO IMPROPER USE OR MISTREATMENT
OF THE UNIT INCLUDING ANY EXTRAORDINARY EVENT LEADING TO THE DAMAGE OF THE MACHINE, WHETHER
IT IS REVERSIBLE OR NOT.
IF THE APL-100 IS NOT LAMINATING PROPERLY, FIRST FOLLOW THE CORRECTIVE ACTIONS ABOVE. IF
THE PROBLEM PERSISTS PLEASE CONTACT YOUR DEALER FOR FURTHER INSTRUCTIONS. PLEASE
HAVE YOUR MACHINE’S SERIAL NUMBER AND THE PURCHASE DATE READY. IF THE MACHINE MUST BE
RETURNED TO YOUR DISTRIBUTOR, IT IS YOUR RESPONSIBILITY TO PROPERLY PACK AND SHIP IT, AS
ANY DAMAGE INCURRED DURING ITS TRANSPORTATION IS NOT COVERED BY OUR WARRANTY
POLICY.