Akiles FlexiCloser User Manual

Page 4

1. When closing smaller wires (3/16” to 9/16”), the Wire Closing Plate can be set to only return half-

way after each closure, in preparation for the next operation. This is to save operating time and

improve efficiency.

2. To check if High Efficiency Mode is currently ENABLED or DISABLED, simply turn off the machine

and then turn it on. Within the first few seconds, the LCD Display will show “LO” (High Efficiency

Mode enabled) or “HI” (High Efficiency Mode disabled).

3. To ENABLE High Efficiency Mode:

a. Make sure High Efficiency Mode is currently DISABLED (see instructions above).

b. Turn off the main power switch.

c. Turn on the main power switch.

d. Press and hold “+” for 5 seconds, or until the LCD Display shows “LO”.

e. High Efficiency Mode has been successfully enabled.

4. To DISABLE High Efficiency Mode:

a. Make sure High Efficiency Mode is currently ENABLED (see instructions above).

b. Turn off the main power switch.

c. Turn on the main power switch.

d. Press and hold “+” for 5 seconds, or until the LCD Display shows “HI”.

e. High Efficiency Mode has been successfully disabled.

5. To bring the Wire Closing Plate back to the top position anytime, simply press Reset/Return

button on the Control Panel.

Your FlexiCloser has a warranty of one year from the date of purchase. In the event of a

manufacturer’s defect, your distributor (at option) will repair or replace it. IMPORTANT: This warranty

does not cover damages due to improper use or mistreatment of the unit, including any extraordinary

event leading to the damage of the machine, whether it is reversible or not.

If the FlexiCloser is not working properly, first follow the corrective actions above. If the problem

persists, please contact your dealer for further instructions. Please have your machine’s serial number

and the purchase date ready. If the machine must be returned to your distributor, it is your

responsibility to properly pack and ship it. Any damage incurred during its transportation is not

covered by our warranty policy.

To prevent the operator’s fingers from being accidently injured by the Wire Closer, your FlexiCloser

is equipped with a Safety Sensor Feature. During wire closing operation, if your finger accidently

touches closing plate, the closing plate will retract automatically.

WARRANTY POLICY

SAFETY SENSOR FEATURE

HIGH EFFICIENCY MODE