Bondioli&Pavesi 399USBR12_A User Manual

Page 16

ENG

Check that all components are in good condition and properly lubricated

before using the driveline. Clean and re-lubricate the driveline before storage

at the end of the season.

Lubricate the parts according to the diagram; lubrication intervals are in expressed

in hours. The lubrication interval for the driveline components is 50 hours. Pump

grease into the crosses until it purges from the bearing caps. Inject the grease

gradually and avoid pumping the grease gun violently with resulting high delivery

pressure. Use NLGI grade 2 grease.

Before storage at the end of the season remove any grease that has accumulated

inside the CV joint shield.

Replace worn or damaged parts with genuine BP C.H.M. spare parts. Do

not modify or tamper with any part of the driveline. For any operations not

explained in this instruction manual, consult your implement dealer or manufacturer,

or your local BP C.H.M. representative.

TORQUE LIMITER AND OVERRUNNING CLUTCH

RA - OVERRUNNING CLUTCH.

This device prevents transmission of inertial loads from implement to the

tractor during deceleration or stopping of the PTO.

Keep clear of the implement until all parts have stopped moving. Lubricate

every 50 hours of use and after storage.

SA RATCHET TORQUE LIMITER.

This device interrupts the transmission of power when the torque exceeds

the setting.

Immediately disengage the PTO when ratcheting sounds are heard.

Lubricate every 50 hours of use and after storage.

LB – SHEAR BOLT TORQUE LIMITER.

This device interrupts the transmission of power by shearing a bolt when the

torque exceeds the setting.

Replace the sheared bolt with the same diameter, length and grade as the original.

Lubricate the LB limiters with grease fittings at least once every season and after

a period of disuse.

FRICTION TORQUE LIMITERS

When installing the device or after a storage period check the operation of the

friction plates:

• release the springs • rotate the clutch while immobilizing the PTO on which is

installed • restore the spring compression to the original value. Following seasonal

use, release the springs and store the clutch in a dry place. Check the condition

of the friction plates and restore spring compression before using the clutch. If the

clutch overheats due to frequent or prolonged slipping, consult your equipment

dealer or your local BP C.H.M. representative.