Vaisala RDP100 - Manual (Page 9)

12. If the DIP switches on the
RDP100 are in off position (new
RDP100), the RDP100 prompts
you to select 1-2 parameters for
display. Use the DIP switches
on the component board to
select the parameters. DIP 8
selects between metric and
non-metric units (for example,
°C or °F for temperature).
The numbers on the parameter
selection screen correspond to
the numbered DIP switches.
13. The parameter selection screen
is shown until 1-2 parameters
are chosen. The measurement
screen appears after a brief
delay when you stop changing
the DIP switch positions.
14. Verify that the display is
showing the parameters and
units you want. You can keep
changing the DIP switch
positions as necessary. The
parameter selection screen will
be shown if necessary.
15. Reattach the front cover to
complete the installation.
7