beautypg.com

Introduction, Preparing for the new installation – State PRG 40 NOMT User Manual

Page 5

background image

referred to as NFPA 54. This publication is available

from your local government or public library or gas

company or by writing NFPA, Batterymarch Park,

Quincy, MA 02269.

3. If after reading this manual you have any questions or

do not understand any portion of the instructions, call

the local gas utility and/or plumbing inspector.

4. Carefully plan the place where you are going to put

the water heater. Correct combustion, vent action, and

vent pipe installation are very important in preventing

death from possible carbon monoxide poisoning and

fires.
Examine the location to ensure the water heater com-

plies with the “Locating the New Water Heater” sec-

tion in this manual.

5. For California installation this water heater must be

braced, anchored, or strapped to avoid falling or mov-

ing during an earthquake. See instructions for correct

installation procedures. Instructions may be obtained

from your local dealer, wholesaler, public utilities or

California Office of the State Architect, 400 P Street,

Sacramento, CA 95814.

6. Massachusettes Code requires this water heater to be

installed in accordance with Massachusetts 248-CMR

2.00: State Plumbing Code and 248-CMR 5.00.

7. Complies with SCAQMD rule #1121 and districts

having equivalent NOx requirements.

Introduction

Thank You

for purchasing this water heater.

Properly installed and maintained, it should give you

years of trouble free service.

Abbreviations Found In This Instruction Manual

CSA - Canadian Standards Association

ANSI - American National Standards Institute

NFPA - National Fire Protection Association

1. Read the “General Safety” section, pages 2 and 3 of

this manual first and then the entire manual carefully. If

you don’t follow the safety rules, the water heater will

not operate properly. It could cause DEATH, SERIOUS

BODILY INJURY AND/OR PROPERTY DAMAGE.

This manual contains instructions for the installation,

operation, and maintenance of the gas-fired water

heater. It also contains warnings through out the manu-

al that you must read and be aware of. All warnings

and all instructions are essential to the proper opera-

tion of the water heater and your safety. Since we can-

not put everything on the first few pages, READ THE

ENTIRE MANUAL BEFORE ATTEMPTING TO INSTALL

OR OPERATE THE WATER HEATER.

2. The gas fired water heater is design certified by CSA

INTERNATIONAL under American National

Standard/CSA Standard ANS Z21.10.1 • CSA 4.1 (cur-

rent edition) for Gas Water Heaters for Manufactured

Home Installation.
Instructions to Manufactured Home Manufacturers:

The installation must conform with the Manufactured

Home Construction and Safety Standards Title 24 CFR,

Part 3280.
Instruction for replacement installation:

The installation must conform with the instructions in

this manual; gas company rules; and Local Codes, or

in the absence of Local Codes, with the current edi-

tion of the National Fuel Gas code, ANSI Z223.1, also

Preparing for the New Installation

5

WARNING

The gas fired water heater is design certified by CSA

INTERNATIONAL under American National

Standard/CSA Standard ANS Z21.10.1 • CSA 4.1 (cur-

rent edition) for Gas Water Heaters for Manufactured

Home Installation.
Instructions to Manufactured Home Manufacturers:

The installation must conform with the Manufactured

Home Construction and Safety Standards Title 24 CFR,

Part 3280.
Instruction for replacement installation:

The installation must conform with the instructions in

this manual; gas company rules; and Local Codes, or in

the absence of Local Codes, with the current edition of

the National Fuel Gas code, ANSI Z223.1, also referred

to as NFPA 54. This publication is available from your

local government or public library or gas company or by

writing NFPA, Batterymarch Park, Quincy, MA 02269.

This manual is related to the following products: