Wixey WR400 3 DIGITAL PROTRACTOR - Manual

For questions, comments, or to view our other products go to
www.wixey.com
Made in China
Barry Wixey Development
5306 Umbrella Pool Road Sanibel, FL 33957
Wixey
TM
Model WR 400
Patented Pending
3” DIGITAL PROTRACTOR
Always turn off and unplug power tools before
using the Digital Protractor
Never use your power tools without properly
installed blade guards. The guards may not be
shown in our instructions only to make the
illustrations clear.
SAFETY FIRST
MEASURE CW
MEASURE CCW
BATTERY
REPLACEMENT
1.Set
zero
here
Negative side up
Type CR2032 Lever tightens blades to
hold measured angles
Set zero
here
Magnets imbedded in
all 4 edges of the blades
Set zero
here
2.Rotate
to 90.0
3.Re-set
zero
Measure CW or CCW
PROBLEM
Flashing Digits
No Display
No Display
Erratic or
Frozen Display
Low Voltage
Low Voltage
Bad Contact
Internal Error
Replace Battery
Replace Battery
Clean Battery
Remove Battery
Wait 1 Minute
and Replace
POSSIBLE
CAUSE
SOLUTION
Measures angles in any plane
Compact design for tight locations
0.1 degree resolution, accuracy, and repeatability
Sets both miter and bevel angles on almost any machine
Strong magnets on all blade edges for ease of use
Blades can be tightened for holding measurements
Range = +/- 180 degrees
Resolution = 0.1 degrees
Accuracy = +/- 0.1 degrees
Repeatability = +/- 0.1degrees Battery replacement
3.0V CR2032
SPECIFICATIONS