Rosendahl mif 4 - Manual (Page 4)

- 4 -
2. Powering up and selecting timecode SOURCE
Connect the USB port to a host computer or use the external power
adapter to supply your mif 4.
Each time the unit is powering up the installed firmware version is
shown in the display for two seconds.
This manual relates to firmware version 2.1 from Oktober 2012.
The left key is used to select the timecode SOURCE.
Short keypresses will navigate through the four input modes:
LTC: longitudinal timecode (SMPTE 12M) from the LTC IN
MTC: midi timecode from the MIDI IN.
USB: midi timecode from a host computer connected via USB.
GEN: manually or MMC controlled timecode generator mode.
Holding down the left key for two seconds causes
(1) a JAM SYNC from applied, running timecode into the GEN mode
(2) or if no timecode signal is present, you will be able to store the
default SOURCE setting to non volatile memory.
(See generator section for more informations about JAM SYNC)