Adaptec PC/104 User Manual
Page 27
Chapter 1 General Information 21
Windows/Windows for Workgroups 3.1x
1.Install Windows 3.1x or Windows for Workgroups 3.1x and start it
running on your computer.
2.Insert the EZ-SCSI Diskette in your floppy disk drive.
3.Select File/Run from the Program Manager menu.
4.When the Run dialog box appear, type a:\setup if you are using the
A drive or b:\setup if you are using the B drive. Then click OK.
5.Following the instructions that appear on the screen.
DOS
1.Install DOS 6.x or above ,and start it running on your computer.
2.Insert the EZ-SCSI Diskette in your floppy disk drive.
3.At the DOS prompt, type a:\dosinst if you are using the A drive or
b:\dosinst if you are using the B drive. Then press Enter.
4.Following the instructions that appear on the screen.