Outback Power Systems FLEXware 1000 Users Guide User Manual

Page 7

Figure 14: FLEXware Wiring Raceway

When all component and cabling installations are complete, install the FLEXware Wiring Raceway
to cover and protect the exposed communication cables running between the AC and DC sides
of the system. The illustration above shows FLEXware Mounting Plates with components removed
for clarity.

A complete FLEXware 1000 System consists of the following in addition to the FW1000-AC
and FW1000-DC:
• two FLEXware Mounting Plates (FW-MP)
• FLEXware Wiring Raceway (included with AC chassis)
• four FX Series Inverter/Chargers
• AC Conduit Adapter (ACA) and a DC Conduit Adapter (DCA), which connect each FX to the
FW1000-AC and FW1000-DC
• MX60 Charge Controller(s) (normally part of this system) and mounting brackets
• AC and DC breakers including a specific AC Input/Output/Bypass Breaker (IOB) Kit
• bus bars and DC current shunts as required per specific installation
• DC and AC ground fault protection

Some systems will work optimally with a FW-X240 Auto-Transformer installed.

Note: Be sure you have all the parts required for your intended system installation. As every
installation is different, consult with your dealer or installer for further information.

FLEXware 1000 Parts List

FLEXware 1000 consists of the FW1000-AC and FW1000-DC. Each is an aluminum chassis for
mounting AC and DC breakers, respectively, along with the components listed below:

FW1000-AC components:
• aluminum enclosure
• DIN rail bracket
• TBB-GROUND
• Breaker and Bypass Mounting Bracket
• FW Wiring Raceway with mounting hardware
• metal hanging straps for combining
two FW-MPs

FW1000-DC components:
• aluminum enclosure
• 500 amp shunt with TBB
• TBB-GROUND
• one FW breaker bus
• two shunt bus bars
• two DC Breaker Mounting Brackets
• FXW1000-DC Hardware Kit

1000 Manual.indd, Spread 7 of 12 - Pages (18, 7) 11/22/06 11:07 AM