Outback Power Systems FLEXware ACA AC Conduit Adapter Users Guide - Manual (Page 3)

2
Figure 1: FW-ACA
Before installing the FW-ACA:
Remove the plastic cover
Determine which knockouts should
be removed
Score the knockout(s) with a utility
knife and punch/pull the selected
knockout(s) until removed
•
•
•
Tools Required to Install: Purpose:
• Phillips screwdriver • Remove and install covers
• Utility knife • Scoring and removing plastic knockouts
• 4 mm Allen wrench • Removing and installing FX M5 hex bolts
• Slotted screwdriver • Remove/install FX AC Wiring Block wires
FW-ACA
The FLEXware AC Adapter or FW-ACA is a plastic case that fi ts on the AC end of an FX Series
Inverter/Charger to extend the size of the AC wiring compartment in OutBack FLEXware systems.
The FW-ACA aligns with knockouts on both the FW500-AC and FW1000-AC enclosures as well as
PS2 and PS4 AC enclosures . It’s knockouts are not designed for conduit, but can accommodate
fl exible cables with appropriate strain relief.
Front view with double knockout Side view with knockout
FW-ACA plastic cover
Knockouts
.810
7.481
1.36 Dia.
(1" EKO)
both sides
1.75" Dia.
(1 1/4" EKO)
6.466
.739
6.840
(2" EKO)
2.50" Dia.