Outback Power Systems Radian Series Inverter/Charger Service Instructions - Manual (Page 8)

Radian Series
8 900-0128-01-00 Rev C
corner). The results of this model change will take effect within 1 minute of making this change. Please allow this
amount of time to pass without making any further changes to settings.
5. Using the MATE3, confirm that the firmware revisions of the Radian inverters on the system are all identical. Also
ensure, in the Stack Mode section, that there is only one MASTER inverter (and it is connected to Port 1 of the HUB)
and the remaining inverters are set to their appropriate settings.
6. Turn on the AC input circuit breakers and an AC input source to verify that the correct voltage is present at the
inverter. Verification can be through a voltmeter or the MATE3.
7. If the system is in bypass mode, return it to normal mode, connecting the AC output of the inverter system to the
loads. Verify that the voltage is correct through a voltmeter or the MATE3.
8. Re-apply power to any other items that were powered down during the repair of the inverter. This may include
reactivating the remote generator start function, if present.
Part replacement is complete.
Contact Information
Address: Corporate Headquarters
17825 – 59 th Avenue N.E.
Suite B
Arlington, WA 98223 USA
European Office
Hansastrasse 8
D-91126
Schwabach, Germany
Telephone:
+1.360.435.6030
+1.360.618.4363 (Technical Support)
+1.360.435.6019 (Fax) +49.9122.79889.0
+49.9122.79889.21 (Fax)
Email: [email protected]
Website: http://www.outbackpower.com
Disclaimer
UNLESS SPECIFICALLY AGREED TO IN WRITING, OUTBACK POWER TECHNOLOGIES:
(a) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF ANY TECHNICAL OR OTHER
INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION.
(b) ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSS OR DAMAGE, WHETHER DIRECT, INDIRECT, CONSEQUENTIAL
OR INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY SUCH INFORMATION
WILL BE ENTIRELY AT THE USER’S RISK.
Notice of Copyright
Radian Series Inverter/Charger Service Instructions © March 2014 by OutBack Power Technologies. All Rights Reserved.
Trademarks
OutBack Power, the OutBack Power logo, FLEXpower ONE, and Grid/Hybrid are trademarks owned and used by OutBack
Power Technologies, Inc. The ALPHA logo and the phrase “member of the Alpha Group” are trademarks owned and
used by Alpha Technologies Inc. These trademarks may be registered in the United States and other countries.
Date and Revision
March 2014, Revision C
Part Number
900-0128-01-00 Rev C