Outback Power Systems GFX Series Inverter/Charger Installation Manual - Manual (Page 11)

900-0113-01-00 Rev A
9
Introduction
Welcome to OutBack Power Technologies
Thank you for purchasing the OutBack GFX Series Inverter/Charger. This product offers a complete
power conversion system between batteries and AC power. It can provide backup power or complete
off-grid service.
 Battery-to-AC inverting which delivers 120 Vac at 60 Hz
 AC-to-battery charging
 Rapid transfer between AC source and inverter output
with minimal delay time
 Inverter load support for a small AC source
 12-, 24-, and 48-volt units
 Wattages from 1.3 kVA to 1.5 kVA
 Stackable in series, parallel, and three-phase
configurations
 Uses energy from PV, wind, and other renewable
sources if appropriate controllers are used
 Grid-interactive capable
Figure 1 GFX Series Inverter/Charger
Models
The GFX Series inverters are designed for harsher environments and can survive casual exposure to
the elements. However, enclosed protection is still recommended. These inverters have an internal
fan, but do not use outside air for cooling.
 GFX1312 (1.3 kVA output, 12 Vdc)
 GFX1424 (1.4 kVA output, 24 Vdc)
 GFX1548 (1.5 kVA output, 48 Vdc)
Inverter model numbers use the following naming convention.
 Grid-interactive models (all models in this series) begin with the letter G. For example, model GFX1424 is
grid-interactive; model VFX3524 is not.
 The model number includes “FX” as the inverter series.
 The first two digits show the wattage of that model. For example, “GFX1312” is 1300 watts.
 The second pair of digits shows the inverter’s nominal DC voltage. For example, “GFX1424” is 24 volts.