Dee Zee DZ6060 - Manual (Page 5)

Page 5 of 6
PS JOBBOX 8/10/09
Attach the bracket to the mounting location using a square neck carriage bolt, washer, lock washer,
and nut. Tighten the nut using a 9/16” wrench or ratchet. Close the lid of the job box and engage the
pad lock. If the lock position is not correct, open the lid, loosen the nut and slide the bracket forward
or backwards as necessary. Tighten the nut and recheck the lock position.
Once the padlock engages and locks the job box, repeat the padlock installation on the other end.
2
F
E D G
TAB SHOULD BE
TOWARDS LID