Dee Zee DZ948 - Manual (Page 4)

Page 4 of 10
DZ 946 / DZ 948 12/10/12
Peel the backing from the adhesive on the foam tape (H) and apply 2 pieces to each bottom surface
of the wheel well toolbox. Place the wheel well toolbox (A) into the truck bed so that the cutout of the
toolbox goes over wheel well of the truck. Move toolbox (A) into desired location in bed of the truck
making sure the hinges of the lid of the box are toward the inside of the truck bed. The left and right
mounting brackets (B/C) are mounted as shown below. Mark the hole locations from the mounting
brackets (B/C) on the inside vertical lip of the bed rail.
1
C
B
A
A
H
Inside Vertical
Lip of Bed