Dee Zee DZ43300 - Manual

FOR INSTALLATION ON DRIVER'S SIDE ONLY
PARTS LIST:
ITEM QTY
NUTSERT TOOL 1
SHOCK 1
CABLE/BALL MOUNT 1
WASHER 1
BALL MOUNT 1
NUTSERT 1
TORX WRENCH 1
CABLE CLIP 1
THREAD LOCK TUBE 1
TOOLS REQUIRED:
T-45 TORX
M5 ALLEN WRENCH
PLIERS
10MM WRENCH
13MM WRENCH/SOCKET
17MM WRENCH
TAPE MEASURE
This product can only be STEP 2) STEP 3)
installed on the driver's side Using a M5 Allen wrench and Mark one side of the nut and Apply thread lock to the
of the vehicle. a 10mm wrench, install the count the number of revolutions threads of the ball mount.
nutsert in the opening by the to insure the correct number Install the ball mount into the
STEP 1) tailgate pivot point. of full turns. nutsert using a 13mm
Adjust the nutsert tool so Overtightening the nutsert wrench/socket.
there is 3/4" from the washer can strip the threads and cause Torque to 8 ft-lbs.
to the head of the bolt. the nutsert to be unusable.
Remove the nutsert tool
when installation is complete.
The nutsert should be tightened 9
360 degree turns.
DZ 43300
DODGE RAM TAILGATE ASSIST
1500 2002-2008
2500/3500 2002-2009
DO NOT TURN
DZ 43300 9/25/2013