Dee Zee RAM-VB-112-SW1 - Manual (Page 2)

Vehicle base for the
INSTALLATION INSTRUCTIONS
If installing this base with a RAM tele-pole™ assembly, attach the lower female pole prior to installing the No-Drill™
base.
1. Move the passenger seat to its rearmost position and remove the plastic trim, covering the seat frame leg closest to
the passenger side door. This piece may be replaced after installation or stored for later use.
2. Remove the front seat rail bolts using a 15MM socket wrench. Using an extension with the socket wrench is
recommended.
3. Without moving the seat, place the No-Drill™ base over the front seat bracket and inline with the exposed threaded
holes.
4. Re-install the seat bolts using the socket wrench with extension. Note that you may need to put some pressure on
the front of the seat cushion to assist in re-aligning the seat rail bolt holes. Start threading the bolts by hand if possible
to prevent any cross threading. Next, re-tighten the bolts.
Once installed, this base will lessen the amount of travel available to the passenger side seat.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-112
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
FORD EXPLORER (2002-NEWER)
FORD EXPLORER SPORT TRAC (2007)
MERCURY MOUNTAINEER (2002-NEWER)