Dee Zee DZ503257 - Manual (Page 2)

BULL BAR
2010 DODGE RAM 25-3500
Page 2 of 2 3/9/10 (DP)
4. Stand back from the vehicle and check to see that the Bull Bar is centered and level on the vehicle
and adjust as necessary. Once properly adjusted, tighten all hardware.
5. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar
Driver Side Installation Pictured
Fig 1
Viewed from behind the
driver/left side of the bumper
Fig 2
(2) 10mm x 35mm Hex Bolts
(4) 10mm Flat Washers
(2) 10mm Lock Washers
(2) 10mm Hex Nuts
Use the factory tow hook hardware
or the included:
(2) 10mm x 35mm Hex Bolts
(4) 10mm Flat Washers
(2) 10mm Lock Washers
(2) 10mm Hex Nuts
Fig 3 Fig 4
Remove factory tow
hook if equipped
Bolt Frame Bracket
up to these (2) holes
Front