Dee Zee DZ501395 - Manual (Page 2)

GRILLE GUARD
05-07 FORD SUPERDUTY F250/350/450/550HD/05-07 EXCUSION
page 1 of 1
• 1 Set
Grille Guard
• 1 Set
Mounting Brackets(left & right,when sitting in
the car)
• 6 pc
M12-1.75 x 50mm Hex Bolts
• 12
pc 12mm Flat Washers
• 6
pc M12 Hex Lock Nuts
Instructions:
NOTE: Please read this information before assembling. Check components received with components
listed above. NO DRILLING IS REQUIRED. Complete step by step instruction sheets will be found on
the following pages.
Illustrations are for reference only, styles vary with application.
IMPORTANT: To obtain correct installation, we recommend you to follow these step by step
instructions carefully.
Please take care when assembling and installing this product to protect the finish and your investment. To
protect your investment, wax this product after installing. Regular waxing is recommended. Do not use
any type of polish or wax that contains abrasive that could damage the finish
Step One: Locate the hardware kit and check it with the hardware listed below
Step Two: Locate the mounting brackets and orient them as per the illustration. Remove the two bumper
bracket bolts that are shown in fig #1. Position the left mounting bracket into place and secure the bracket
to the frame as shown in fig #1 using the factory bolts. Do not fully tighten hardware at this time. Repeat
this procedure on the right side.
Step Three: Position the Grille guard between the mounting brackets and loosely attach with the M12
hardware.
Step Four: After making sure the guard is level and square to the vehicle, completely tighten all hardware
at this time.
Fig #1
3pcs M12-1.75 x 50mm Hex Bolts
6pcs 12mm Flat Washers
3pcs M12 Hex Lock Nuts