Dee Zee DZ503245 - Manual (Page 6)

GRILLE GUARD
09-ON DODGE RAM
Page 4 of 6 12/30/08 Rev2(DP)
Driver Side Installation Pictured
Driver Side Installation Pictured
Pry up the center pin on the clip to remove the complete
fastener. If the center pin comes out, remove the housing then
push the pin back into the housing as per Fig 1B to reinstall.
(Fig 1A) Viewed from behind the center of the bumper
Fig 1B Pin
Housing
IMPORTANT: On trucks without
tow hooks, use only the supplied
12-1.5mm x 30mm Fine Thread
Hex Bolt
12mm Flat Washer
12mm Lock Washer
(Fig 2A) Driver side mounting locations viewed from
behind the bumper (non tow hook equipped models)
Front
(Fig 3A) Driver side mounting locations viewed from
behind the bumper (tow hook equipped models)
Front
Installation pictured
without the splash
guard for illustration
Upper Frame
Mounting Bracket
installation
(pictured with
Support Bracket
installed)
For illustration only, clips may
differ depending on model
Fig 2B
Fig 3B
Pictured with
Support Bracket
installed