Dee Zee DZ501795 - Manual (Page 2)

Installation Instructions
One Piece Grille Guard Part# DZ 501794/501795
03-06 Chevy Silverado HD
NOTE: Carefully read this information before attempting to install this product. The manufacturer is in no way
responsible for any damage to the vehicle or personal injury that may occur during the installation or use of this product.
Check components received with components listed below. NO DRILLING REQUIRED.
QTY
DESCRIPTION
1 One Piece Front Guard
1 Upper Support Bracket-left
1 Upper Support Bracket-right
1 Lower Support Bracket-left
1 Lower Support Bracket-right
8 M12 x 30 Hex Bolt-zinc plated
6 M12 Lock Nut-zinc plated
14 M12 Flatwasher-zinc plated
2 M10 x 25 Hex Bolt-zinc plated
2 M10 Lock Nut-zinc plated
4 M10 Flatwasher-zinc plated
Step One: Locate the Upper Support Brackets. Using the factory bolts loosely attach them to the vehicle as shown in
Figure #2.
Step Two: Remove the factory tow hooks from the vehicle if so equipped. If the vehicle did not come with the factory
tow hooks it is necessary cut out the area of the lower valance where the hooks would have been.
Step Three: Locate Left Lower Support Bracket, Two M12 x 30 Bolts, One Lock Nut, and Three Flat washers. Position
the bracket in the frame. Loosely attach the Left Lower Support Bracket to frame using the hardware listed in this step
(Figure 1). Repeat this procedure on the opposite side of vehicle.
Step Four: Using the remaining M12 x 30 Hex Head Bolts, M12 Lock Nuts, and M12 Flat Washers, position the Guard
to the inside of the Lower Support Brackets. Loosely attach Guard to Bottom Support Brackets using the hardware listed
in this step (Figure 1).
Step Five: Locate M10 x 25 Hex Head Bolts, M10 Lock Nuts, and M10 Flat Washers. Bolt the Front Guard to the Top
Support Brackets using the hardware listed in this step (Figure 2).
Step Six: After checking for proper clearance and alignment of the Front Guard on the vehicle fully tighten all hardware.