Dee Zee DZ3019 - Manual (Page 3)

DZ 3019 10/17/97 PAGE 2
**If you should incur any problems with the installation of this product, please feel free to call us at 1-800-779-8222.
So that we may better serve you when you call, please have the W/O#, SEQUENCE#, and the DATE
from the labels on the outside of the box.
WARNING: It is unlawful and dangerous to ride on running boards or
side box boards while vehicle is in motion. It is the sole responsibility
of the owner to check for tire clearance. CLEANING INSTRUCTIONS: To maintain the bright finish of your
Dee Zee aluminum running boards, clean with a mild detergent.
STEP 4
At approximately 53" from the front of the board, position an L-
brace to the sub-body support and the rear of the board. Use the
first and third holes in the L-brace as a guide to drill two
1/4" holes through the running board step. Secure in place with
1/4" x 1" carriage bolts (C), washers and nuts (N). Level the
running board to the vehicle. Use the holes in the top of the brace
as a guide to drill two 3/16" holes through, the sub-body support.
Attach with two 1/4" x 1" sheet metal screws (E).
STEP 5
At approximately 30" back from the front of the running board,
position channel brace to the underside of the running board and
sub-floor support as shown. Use the holes in the channel brace
as a guide to drill two 1/4" holes through the running board step.
Secure in place with 1/4" x 1" carriage bolts (C), washers and
nuts (N).
Use the hole in the opposite end of the channel brace as a guide
to drill one 1/4" hole up through the sub-floor support and attach
the channel brace to the sub-floor support using a 1/4" x 3/4" hex
head bolt (J), washer and nut (N).