Dee Zee DZ16251 - Manual (Page 7)

Page 7 of 8
DZ 16251 04/15/09
On the inside side opposite the tab on bracket (B), place bracket (E) and using 8mm x 25mm
Hex Head bolt (K) and 8mm hex nuts (L) in 2 locations secure the brackets by tightening, but
do not tighten completely. Then insert the 8mm x 25mm Hex Head bolt (K) through the
bracket tabs in the front as shown below and secure on the top side with M8 – 1.25 single tab
weld nuts (J). In the rear location secure with M8 – 1.25 2 tab weld nut (I). Place bracket
assembly in rear driver location and tighten all fasteners in position, but do not tighten
completely.
4
I
B
G
J
13 mm
K
K
L
J
K