Dee Zee DZ17002 - Manual (Page 9)

Page 9 of 9
DZ 17002-DZ 17502 04/10/08
Make sure that the nerfstep is level and then tighten all of the fasteners until snug. The rear
rocker panel bracket should be snug against the inside of the rocker panel. You will secure
the rear rocker panel bracket to the inside rocker panel by first drilling a ¼” hole through the
rocker panel lip. Secure the bottom of the rocker panel bracket to the rocker panel using a ¼”
x 1” ribneck carriage head bolt (G), ¼” flat washer (H), and ¼” hex nut (I).
Use the top holes in the rocker panel bracket as a guide to drill two 3/16” holes through the
inside of the rocker panel. Secure the top of the rocker panel bracket to the rocker panel
using ¼ x 1” sheet metal screws (J).
7
8