Dee Zee DZ17004C - Manual (Page 6)

Page 6 of 6
DZ 17004 02/13/09
Place the driver side mounting brackets (C) up to the front, middle, and rear rocker panel
bracket locations as shown below. Note: the mounting bracket will fit to the inside of the
rocker panel bracket. Secure into place using an 8mm x 25mm hex flange bolt (E) and 8mm
hex flange nut (F). Leave loose for later adjustment.
Place the nerfstep up to the mounting brackets. The bent end of the nerfstep will go to the
front of the vehicle. Secure each of the mounting brackets to the nerfstep using 6mm hex
flange bolts (H) and 6mm washers (I). Tighten into place using a 10mm wrench / or socket.
Now tighten all of the fasteners until snug.
3
4