Dee Zee DZ370299 - Manual

3”& 4” 90DEG BENT END SIDEBARS
97-03, 04 HERITAGE FORD SUPERCAB F-150, F-250 LIGHT DUTY
Page 1 of 3 7/8/09Rev4(DP)
PARTS LIST:
1 Driver/Left Sidebar 2 10mm Offset Double Bolt Plates (for front)
1 Passenger/Right Sidebar 2 10mm Double Bolt Plates (for rear)
1 Driver/Left Front Mounting Bracket 8 10mm ID x 27mm OD x 3mm Flat Washers
1 Passenger/Right Front Mounting Bracket 8 10mm Lock Washers
1 Driver/Left Rear Mounting Bracket 8 10mm Hex Nuts
1 Passenger/Right Rear Mounting Bracket 2
10mm Plastic Retainers (for Narrow Bolt Plate use
only)
4 1/2” x 2” Hex Bolts 8 8mm x 25mm Hex Bolts
4 1/2” Lock Washer 16 8mm x 24mm OD x 2mm Flat Washers
4 1/2” ID x 1 1/2” OD x 1/8 Flat Washers 8 8mm Lock Washers
1
10mm Narrow Double Bolt Plate (for driver side
rear on 3-Door models only)
8 8mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From under the driver side front of the vehicle, remove the oval grommet located on the inside
of the rocker panel, (Figure 1). Insert (1) Offset Double Bolt Plate, (with threaded studs toward
the top), into the factory oval hole, (Figure 2).
3. Locate the driver side front Mounting Bracket. Hold the Double Bolt Plate from one side while
you position and attach the Mounting Bracket to the opposite side. Secure the Bolt Plate with
one 10mm Flat Washer, 10mm Lock Washer and 10mm Hex Nut. Proceed to install the rest of
the hardware to secure the Mounting Bracket to the Double Bolt Plate. (Figure 3). Do not
tighten hardware at this time.
4. Align the Mounting Bracket with holes in the pinch weld. Attach the Mounting Bracket to the
pinch weld using the included (2) 8mm x 25mm Hex Bolts, (4) 8mm Flat Washers, (2) 8mm
Lock Washers and (2) 8mm Hex Nuts. NOTE: Insert Bolt with Flat Washer from the outside-in.
Do not tighten hardware at this time.
5. Moving to the rear, use one of the (centered) Double Bolt Plates and hardware to install the
Rear Bracket. Repeat steps 2 – 4 for driver side rear Mounting Bracket.
Note for 1997-98 3-Door models only: The 3-door model uses the included (1) 10mm
Narrow Bolt Plate for driver side rear Bolt Plate installation. Thread (1) 10mm Plastic
Retainer partially onto (1) threaded end on the Bolt Plate, (Figure 5). Insert the other
Driver Side
Front Mounting
Bracket
Driver Side
Rear
Mounting
Bracket
Passenger Side Front
Mounting Bracket
Passenger
Side Rear
Mounting
Bracket
Offset Double Bolt Plates
(for front)
Double Bolt Plates
(for rear)
Installation
Complete
Driver Side Pictured.
Note step pad location
Narrow Double Bolt Plate
(for rear 3-Door only)