beautypg.com

Dee Zee DZ372529HD User Manual

Page 2

background image

4" OVAL SIDEBARS BODY BOLT MOUNT

2014 SILVERADO/SIERRA 1500 DOUBLE CAB

Page 1 of 3

9-4-13 (DP)

PARTS LIST:

Qty

Description

Qty

Description

1

Driver/Left Sidebar

4

1/2” x 2” Hex Bolts

1

Passenger/Right Sidebar

4

1/2” Lock Washers

1

Driver/Left Front Mounting Bracket

4

1/2” x 1-1/2" OD x 1/8" Flat Washers

1

Passenger/Right Front Mounting Bracket

2

8-1.25mm x 25mm Hex Bolts

2

Center Brackets (left or right)

2

8mm Lock Washers

1

Driver/Left Rear Mounting Bracket

2

8mm x 24mm x 2mm Flat Washers

1

Passenger/Right Rear Mounting Bracket


















PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTALLATION INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
ASSISTANCE IS RECOMMENDED.
1.
Start at the front of the passenger side of the vehicle. Remove the front body mount bolt,

(Figure 1).

2. Select the passenger side front Mounting Bracket. Insert the factory body mount bolt through

the Mounting Bracket, factory washer and up into the mount. Snug but do not fully tighten the
body bolt at this time, (Figure 2). VERY IMPORTANT! To prevent unnecessary noise,
adjust the position of all Mounting Brackets so that once tightened, the Mounting
Brackets cannot come in contact with the factory steel body mount bracket.

3. Repeat Steps 1 & 2 for Center Mounting Bracket installation, (Figures 1 & 3).
4.
Move toward the rear of the vehicle. Remove the factory body mount bolt as described in Step

1. Select the driver side Rear Mounting Bracket, (Figure 4). Bolt the rear Mounting Bracket in
place as previously described, (driver side pictured in Figure 5).

5. With assistance, position the Sidebar up to the front and rear Mounting Brackets. Attach the

Sidebar to the Brackets with the included (2) 1/2

” x 2” Hex Bolts, (2) 1/2” Lock Washers and (2)

1/2” Flat Washers, (Figures 4 & 5). Do not tighten hardware at this time.

6. Attach the center Mounting Bracket to the Sidebar with the included (1) 8mm x 25mm Hex

Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer, (Figure 6). Do not tighten hardware at
this time.

Driver/Left rear
Mounting Bracket

Driver/Left front
Mounting Bracket

(2) Center Mounting
Brackets

Passenger/Right front
Mounting Bracket

Passenger/Right rear
Mounting Bracket

Front

Driver/Left Sidebar

Passenger/Right Sidebar

This manual is related to the following products: