Dee Zee DZ372519HD - Manual (Page 2)

4" OVAL SIDEBARS BODY BOLT MOUNT
2014 SILVERADO/SIERRA 1500 REGULAR CAB
Page 1 of 2 10-17-13 (DP)
PARTS LIST:
Qty Description Qty Description
1 Driver/Left Side Bar 1 Passenger/Right Rear Mounting Bracket
1 Passenger/Right Side Bar 4 1/2” x 1-1/2" OD x 1/8" Large Flat Washers
1 Driver/Left Front Mounting Bracket 4 1/2” Lock Washers
1 Passenger/Right Front Mounting Bracket 4 1/2” x 2” Hex Bolts
1 Driver/Left Rear Mounting Bracket
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTALLATION
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
1. Start installation on the front, passenger side of the vehicle. Remove the factory front body mount bolt,
(Figure 1).
2. Select the passenger side front Mounting Bracket. Insert the factory body mount bolt through the
Mounting Bracket, factory washer and up into the mount. Snug but do not fully tighten the body bolt at
this time, (Figures 2 & 3). VERY IMPORTANT! To prevent unnecessary noise, adjust the position
of all Mounting Brackets so that once tightened, the Mounting Brackets cannot come in contact
with the factory steel body mount bracket.
3. Move toward the rear of the vehicle. Remove the factory body mount bolt as described in Step 1.
Select the driver side Rear Mounting Bracket. Bolt the rear Mounting Bracket in place as previously
described in Step 2, (Figure 4).
4. With assistance, position the Sidebar up to the front and rear Mounting Brackets. Attach the Sidebar to
the Brackets with the included (2) 1/2 ” x 2” Hex Bolts, (2) 1/2” Lock Washers and (2) 1/2” Flat Washers,
(Figures 3 & 4). Do not tighten hardware at this time.
5. Level and adjust the Sidebar, tighten all hardware and check all mounting locations for clearance
between factory steel body mount brackets and Mounting Brackets. Once satisfied with fit, tighten all
hardware.
6. Repeat Steps 1 - 5 for driver Sidebar installation.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver/Left rear
Mounting Bracket
Driver/Left front
Mounting Bracket
Passenger/Right front
Mounting Bracket
Passenger/Right rear
Mounting Bracket
Front
Driver/Left Sidebar Passenger/Right Sidebar