ATN PS 14 - Manual (Page 7)

5 6
ADJUSTING
1) Loosen the tightening knob [2] on the
rail to enable you to easily slide the unit on.
Don’t retighten the knob yet.
2) Loosen the top horizontal fixation knob
[3]. Adjust goggle horizontal position.
Tighten horizontal fixation knob.
3) Loosen the side vertical fixation knob
[4]. Adjust goggle vertical position. Tighten
vertical fixation knob.
NOTE: The helmet mount has the addi-
tional ability for vertical adjustment. You
can displace the rail to another vertical
position if need be [ 5].
4) Adjust Eye Relief by sliding the PS-14 on the rail toward or away from eyes. Then
tighten the fixation knob [2] on the rail.
5) Goggles can be flipped up when not in use. Loosen the side vertical fixation knob [4].
Upright the unit and fix in this position with fixation knob.
WEAPON MOUNT
(OPTIONAL)
Weapon mount adapter allow the system to be
mounted on the M16/M4 Picatinny style rail.
1) Install the Picatinny weapon mount adapter [1]
on to the rail.
2) Mount the cleat [2] to body of PS-14.
3) Push the fixation lever [3] and move PS-14
ahead to the slot of weapon adapter [4] until fixa-
tion .
CAMERA ADAPTER
( O P T I O N A L)
To use your PS-14 with a 35mm camera or camcorder you will need the following:
1) If you plan to use a camcorder then your camcorder must have a MACRO feature. Most
modern camcorders today have a MACRO feature built-in.
2) If you plan to use a 35mm camera, you will need a MACRO lens. If you don’t have one, we
advise that you contact your local camera store.
3) You may or may not need a STEP-UP or STEP-DOWN ring in order to adapt the camera
adapter to your lens. NOTE: The camera adapter comes with 37mm and 52mm threads. If you
need other sizes your local camera store should be able to help.
3
1
4
5
2
1
2
3
4