ATN PS 14 - Manual (Page 5)

3 4
450 MW INFRA-RED ILLUMINATOR
The 450 mW IR Illuminator works on a sepa-
rate battery from the main unit. To install the
battery unscrew cap and insert battery in the
same direction as depicted by the diagram
on the IR. To install the 450mW IR Illumina-
tor to the scope screw the adapter into the
thread on the scope. Install IR to the rail of
adapter and screw fixator.
The IR illuminator control buttons are
located on its side. To switch the Digital IR
illuminator on/off press “+” and “-” buttons
simultaneously. When the IR illuminator is
switched on you can see the green LED lit.
By pushing the buttons “ +” and “-” you may
adjust the IR brightness.
The IR beam is focusable to change the field
of coverage. To change the beam width slightly turn the IR lens.
You could change the IR control panel fitting your needs. The screw-tool included into the set
should be used for weakening the fixing screw located on the IR. Rotate the IR placing it in the
most convenient position. Tighten the screw with the screw-tool to fix the new position.
FLIP-UP HEADSET
PART I
1) The first step that you want to take in
mounting PS-14 on your head is to fit the
headgear to your size. Adjust the headgear
fist before attaching the PS-14 to it.
2) Loosen all the straps and place the head-
gear on your head.
3) You will want to tighten the straps.
PART II
Now you are ready to mount the PS-14 on to
your headgear.
1) Remove the already adjusted headgear
from your head.
2) Screw the thumb screw [1] to the mounting
thread in the body of PS-14.
3) Get the headgear on with PS-14 onto the
head.
4) Loosen the screw [2] and move the unit
along the rail for eye relief adjusting .
The PS-14 headset has a flip-up mechanism.
Push a button [3] on the side of mount and lift
the unit up till a fixation in the top position.
You can use PS-14 for left eye. Loosen the
screw [4] and rotate unit to new position.
1
2
3
Battery
Housing
Fixation
Screw
IR Elevation
IR Windage IR Focusing
IR Brightness Adjustment
4
Adapter