Dee Zee DZ371519 - Manual (Page 4)

4” OVAL SIDEBAR WITH BEND
1999-11 CHEVY SILVERADO REGULAR CAB
Page 2 of 3 10/6/09 (DP)
PARTS LIST:
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From underside of vehicle, remove the passenger side front body mount bolt, steel washer (if
equipped), and rubber bushing, (Figure 1).
3. Select the driver side front Mounting Bracket. Insert the factory body mount bolt through the
Mounting Bracket and into the steel washer, (if equipped), and rubber bushing. Hang the
Mounting Bracket in position by partially threading the factory body mount bolt up into place,
(Figure 1). Repeat this step for driver rear Mounting Bracket, (Figure 2). Snug but do not
tighten hardware at this time.
NOTE: There are several different designs, (depending on model year), for the factory
steel body mount bracket. The Sidebar Mounting Brackets can be switched, driver side
to passenger side, to provide additional clearance between the gusset on the Mounting
Bracket and the factory steel body mount bracket welded to the frame. The front
Mounting Brackets however, are not interchangeable with the rear Mounting Brackets.
To prevent unnecessary noise, adjust the position of the Mounting Brackets so that the
Brackets do not come in contact with the factory steel body mount bracket.
4. Carefully position the driver/left Sidebar up to the Mounting Brackets. Attach the Sidebar to the
Mounting Brackets with the included (2) 1/2” x 2” Hex Bolts, (2) 1/2” Lock Washers and (2) 1/2”
Flat Washers, (Figures 2 & 3). Snug but do not tighten hardware at this time.
5. Level and adjust the Sidebar, check Mounting Brackets for clearance between factory steel
body mount brackets. Once satisfied with fit, tighten all hardware.
6. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
1 Driver/Left Sidebar 1 Passenger/Right side rear Mounting Bracket
1 Passenger/Right Sidebar 4 1/2” x 2” Hex Head Bolts
1 Driver/Left side front Mounting Bracket 4 1/2” Lock Washers
1 Passenger/Right side front Mounting Bracket 4 1/2” ID x 1-1/2" OD x 1/8" Flat Washers
1 Driver/Left side rear Mounting Bracket
(C) (C)
Driver/Left Front
Mounting Bracket Passenger/Right Front
Mounting Bracket
Passenger/
Right Rear
Mounting
Bracket Driver/Left
Rear
Mounting
Bracket
Complete Installation