Dee Zee DZ371331 - Manual

Page 1 of 4 11/25/08 Rev 1(DP)
PARTS LIST:
Qty Description Qty Description
1 Driver/Left Sidebar 4 10mm Clip Nuts
1 Passenger/Right Sidebar 6 12mm x 37mm OD x 3mm Flat Washers
1 Driver/Left front Mounting Bracket 6 12mm Lock Washers
1 Passenger/Right front Mounting Bracket 6 12mm Hex Nuts
1 Driver/Left rear Mounting Bracket 4 10-1.50mm x 35mm Hex Bolts
1 Passenger/Right rear Mounting Bracket 4 10mm x 30mm OD x 2.5mm Flat Washers
4 1/2” x 2” Hex Bolts 4 10mm Lock Washers
4 1/2” x 1-1/2” x 1/8” Flat Washers 8 8-1.25mm x 30mm Hex Bolts
4 1/2” Lock Washers 16 8mm x 24mm OD x 2mm Flat Washers
2 12mm X 40mm single bolt plates 8 8mm Lock Washers
2 12mm X 45mm double bolt plates 8 8mm Hex Nuts
4 12mm plastic retainers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the passenger side-front of the vehicle, locate the round and rectangular openings
in the inner body panel. NOTE: Mounting holes may be covered with rubber plugs and/or
sealing tape. Remove to uncover mounting locations. Insert (2) 10mm Clip Nuts (with the nut
portion to the inside) into the rectangular opening and line up the threaded nut with the factory
round holes, (Figure 1). Next, partially thread (1) 11mm Plastic Retainer onto (1) 12mm Bolt
Plate, (Figure 2), and insert the Bolt Plate into the large round hole. Once inserted, thread the
Plastic Retainer onto the threaded end of the Bolt Plate until it is flush against the body panel.
NOTE: When properly installed, the Plastic Retainer is designed to prevent the Bolt Plate from
falling into the body cavity during Bracket installation.
INSTALLATION INSTRUCTIONS
3”& 4” 90DEG BENT END SIDEBARS
04-08 F-150 REGULAR CAB
PART NUMBER
Driver Side
Front Mounting
Bracket
Driver Side Rear
Mounting Bracket
Passenger Side
Front Mounting
Bracket
Passenger Side
Rear Mounting
Bracket
12mm Bolt
Plates
12mm Double Bolt
Plates
(for rear)
(4) 11mm Plastic
Retainers