beautypg.com

Installation instructions – Dee Zee DZ370291 User Manual

Page 2

background image





PARTS LIST:

1 Driver/Left Sidebar

2 10mm Offset Double Bolt Plates (for front)

1 Passenger/Right Sidebar

2 10mm Double Bolt Plates (for rear)

1 Driver/Left Front Mounting Bracket

8 10mm ID x 27mm OD x 3mm Flat Washers

1 Passenger/Right Front Mounting Bracket

8 10mm Lock Washers

1 Driver/Left Rear Mounting Bracket

8 10mm Hex Nuts

1 Passenger/Right Rear Mounting Bracket

8 8mm x 25mm Hex Bolts

4 1/2” x 2” Hex Head Bolts

16 8mm x 24mm OD x 2mm Flat Washers

4 1/2” Lock Washers

8 8mm Lock Washers

4 1/2” ID x 1-1/2” OD x 1/8 Flat Washers

8 8mm Hex Nuts













PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. From underside of the vehicle, remove the driver side front oval grommet located on the side

panel, (Figure 1). Insert (1) Offset Double Bolt Plate into factory oval hole, (Figure 2).

3. Locate driver side front Mounting Bracket. Hold Double Bolt Plate from one side while you

position and attach Mounting Bracket to opposite side. Once you secure the Bolt Plate with
one nut, lock washer and flat washer, proceed to attach the second nut on the Double Bolt
Plate. Use the included (2) 10mm Hex Nuts, (2) 10mm Lock Washers and (2) 10mm Flat
Washers, (Figure 3A, 3B). Do not tighten at this time.

4. Align bracket with holes in pinch weld. Attach the Mounting Bracket to pinch weld using the

included (2) 8mm x 25mm Hex Head Bolts, (2) 8mm Lock Washers, (4) 8mm Flat Washers
and (2) 8mm Hex Nuts. NOTE: Insert Bolt with Flat Washer from the outside-in. Do not tighten
at this time.

5. For the rear, use one of the Double Bolt Plates with bolts in the center to install the Rear

Bracket. Repeat steps 2 – 4 for driver side rear Mounting Bracket. Depending on application,
pinch weld area may align with only one hole from the factory. If desired, installer may drill
through Pinch Weld for second Pinch Weld bolt. Do not drill for second hole until the Sidebar

Page 1 of 2 4/13/09 Rev 3(DP)

INSTALLATION INSTRUCTIONS

3”& 4” 90DEG BENT END SIDEBARS

99-03, 04 HERITAGE FORD SUPER CAB F-150, F-250 LIGHT DUTY

PART NUMBER #

Installation

Complete

Driver Side Front

Mounting Bracket

Driver Side Rear

Mounting Bracket

Passenger Side

Front Mounting

Bracket

Passenger Side

Rear Mounting

Bracket

Offset

Double Bolt

Plates

(for front)

Double Bolt

Plates

(for rear)